3/10/2024 0 Comments Behringer patchbay templateI attach the labels to my patchbay using rubber cement. Then drill the holes in the label, using the backing material for support. Start by clamping piece of rigid backing material to the table (I used a scrap piece of FR4 fibreglass circuit-board material). A regular twist drill will just tear the paper. For punching out the holes, I use a 7/16″ Forstner drill bit in my drill press. I print the labels on my inkjet using photo paper, mainly for the extra stiffness compared to plain paper.Īt this point, you can either cut out just the two label strips and attach them to your patchbay, or you can punch out the holes for the jacks and attach the entire faceplate at once. They’re kinda cryptic, I guess, but clear enough to me. I also created some icons to represent the “normalled”, “half-normalled”, “parallel” and “thru” patchbay configurations. You can optionally use Format/Borders and Shading to colour the cells. To use it, just click in the table cell above or below the jack, and type in the label. It actually fits two complete faceplates on one page. To fit on 8.5″x11″ paper, I split it onto two lines. ![]() It is basically an image of the front of the patchbay that I captured from Behringer’s PDF documentation, with a Word table overlayed on it. And here it is filled out with my own current configuration.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |